Try to connect your device manually and perform a test cut to determine what connection is the correct one for your device. Note: 1) If the cutter doesnt return to the home position or. If the system is unable to automatically detect your device, it may simply mean that it was always available in the list For details, see section 3-2-5, Eth- ernet Interface Cable. Why can i not manually enter my port name B002? At this point the only thing i can get it to do is draw a test star using the control panel with my pen carriage on paper, i do not have any vinyl right now and do not need any until i can get the plotter to communicate with my computer. My computer recognizes the plotter under my devices and printers.
![make the cut 4 1 0 serial port make the cut 4 1 0 serial port](https://aws1.discourse-cdn.com/arduino/optimized/4X/2/6/4/264e95b52691d3fd0be8281803af38c29cf4a1a8_2_482x500.jpeg)
When i try to detect the port name the wizard just makes me cut the plotter on/off over and over but it never changes anything. I already had the port type selected to direct com port. An FTDI FT232RL on the board channels this.
![make the cut 4 1 0 serial port make the cut 4 1 0 serial port](https://m.media-amazon.com/images/I/51oFSg-YkoL._AC_SY450_.jpg)
Select the adapter and right click to open the menu.
![make the cut 4 1 0 serial port make the cut 4 1 0 serial port](https://cdn-learn.adafruit.com/guides/cropped_images/000/000/014/medium640/397.jpg)
#Make the cut 4 1 0 serial port windows#
I did also change the baud rate on the actual plotter, it will not allow me to choose 4800 baud rate in the vinyl spooler window. The ATmega328 provide UART TTL (5V) serial communication, which is available on digital pins 0 (RX) and 1 (TX). To change the default COM port used to communicate with multiport serial boards, do the following: Go to Windows Device manager > Multi-port serial adapters. I've downloaded and installed everything that was recommended, in order.